Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › TRANSMISSION CONTROL CABLE (for Floor Shift Type)

TRANSMISSION CONTROL CABLE (for Floor Shift Type) > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


C157286
  1. Insert the floor shift transmission control cable from the vehicle interior, and install the cable retainer with the 2 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



    C157287E01
  1. Install the cable outer of the transmission control cable to the shift lever retainer, and install a new clip.



    C158381E01
  1. Connect the control cable end to the shift lever.

    NOTICE:
    Make sure to install the cable end so that the inner cable is not twisted. Confirm that the cable end's ridged side is facing upward.

  1. Move the shift lever to the N position.



    C155873E01
  1. Turn the control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.



    C158380E01
  1. Connect the control cable with a new clip and the nut.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }

    NOTICE:
    When connecting the cable to the transmission control shaft lever, make sure the cable's L bracket faces the inside of the vehicle.



    C157285
  1. Connect the transmission control cable support with the nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



2. ADJUST SHIFT LEVER POSITION
  1. Move the shift lever to N.



    C155901E03
  1. Fold back the transmission control cable adjust case cover. Then while sliding the slider toward the cable end side, press the lock piece from the back side to release the lock.
    Text in Illustration 
    *1
    Lock Piece
    *2
    Slider



    C155902E03
  1. Check that the spring of the adjust case is applying enough tension to the shift control cable. Then press the lock piece to set the lock.
    Text in Illustration 
    *1
    Lock Piece
    *2
    Slider

    NOTICE:
    1. Use your hand to push the lock piece. Do not use any tools.
    2. Securely push the lock piece so that the protrusion of the slider is above the lock piece.

  1. Return the cover of the adjust case to its original position.

  1. Inspect the operation after the adjustment.



3. INSPECT SHIFT LEVER POSITION
  1. When moving the shift lever from N to other positions, check that the lever can be shifted smoothly and accurately to each position and that the position indicator comes on in accordance with the shift lever position.
    If the indicator and shift lever position do not match, carry out the following adjustment procedures.



4. INSTALL CONSOLE BOX ASSEMBLY
(Click here)