Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Indicator Circuit

for Preparation Click here


DESCRIPTION

The sonar ON/OFF indicator light and warning indicator lights are installed in the combination meter assembly.

WIRING DIAGRAM


E280654E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - COMBINATION METER ASSEMBLY)
  1. Disconnect the J35 clearance warning ECU assembly connector.

  1. Disconnect the J28 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J35-7 (L1) - J28-8 (RR)
    Always
    Below 1 Ω
    J35-8 (L2) - J28-9 (RL)
    Always
    Below 1 Ω
    J35-23 (L3) - J28-4 (BK)
    Always
    Below 1 Ω
    J35-9 (L4) - J28-6 (FR)
    Always
    Below 1 Ω
    J35-24 (L5) - J28-7 (FL)
    Always
    Below 1 Ω
    J35-10 (L10) - J28-5 (OP)
    Always
    Below 1 Ω
    J35-7 (L1) - Body ground
    Always
    10 kΩ or higher
    J35-8 (L2) - Body ground
    Always
    10 kΩ or higher
    J35-23 (L3) - Body ground
    Always
    10 kΩ or higher
    J35-9 (L4) - Body ground
    Always
    10 kΩ or higher
    J35-24 (L5) - Body ground
    Always
    10 kΩ or higher
    J35-10 (L10) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK COMBINATION METER ASSEMBLY
  1. Replace the combination meter assembly with a normally functioning or new one (Click here).

  1. Check that the multi-information display in the combination meter assembly operates normally.

    OK:
    Multi-information display in the combination meter assembly operates normally.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (COMBINATION METER ASSEMBLY IS DEFECTIVE)