Home › ENGINE ยท 1UR-FE › EMISSION CONTROL › AIR PUMP

AIR PUMP > REMOVAL

for Preparation Click here



1. DISCONNECT FRONT FENDER LINER RH
(Click here)

HINT:
It is not necessary to fully remove the front fender liner RH.
Partially remove it so that the air pump assembly with bracket can be removed in a later step.



2. DISCONNECT FRONT FENDER APRON SEAL RH


    A153461
  1. Using a clip remover, remove the 2 clips and fold back the front fender apron seal RH.



3. REMOVE NO. 2 AIR INJECTION SYSTEM HOSE


    A307705E01
  1. Engine Room Side:
    Text in Illustration 
    *a
    Engine Room Side
    *b
    Front Fender RH Inside

    1. Detach the 2 clamps.

    2. Slide the clamp indicated by the arrow in the illustration and disconnect the No. 2 air injection system hose from the air tube.

  1. Front Fender RH Inside:

    1. Slide the clamp and disconnect the No. 2 air injection system hose from the air pump assembly.



4. REMOVE NO. 3 AIR INJECTION SYSTEM HOSE


    A307706E01
  1. Engine Room Side:
    Text in Illustration 
    *a
    Engine Room Side
    *b
    Front Fender RH Inside

    1. Detach the clamp.

    2. Slide the clamp indicated by the arrow in the illustration and disconnect the No. 3 air injection system hose from the air tube.

  1. Front Fender RH Inside:

    1. Detach the clamp.

    2. Slide the clamp indicated by the arrow in the illustration and disconnect the No. 3 air injection system hose from the air pump assembly.



5. REMOVE AIR PUMP ASSEMBLY WITH BRACKET


    A214252
  1. Disconnect the 2 air pump connectors and detach the 3 wire harness claws.



    A302341
  1. Remove the 2 bolts, 2 nuts and air pump assembly with bracket.



6. REMOVE AIR PUMP INLET


    A273866E02
  1. Remove the 2 bolts, slide the 2 clamps off of the No. 1 air injection system hoses, disconnect the No. 1 air injection system hoses from the air pump inlet.
    Text in Illustration 
    *1
    No. 1 Air Injection System Hose
    *2
    Air Pump Inlet



7. REMOVE NO. 1 AIR INJECTION SYSTEM HOSE
  1. Remove the 2 No. 1 air injection system hoses from the 2 air pump assemblies.



8. REMOVE AIR PUMP ASSEMBLY


    A302343
  1. Using a clip remover, detach the 2 wire harness clamps and remove the 2 air pump assemblies from the air pump bracket.

  1. Disconnect the 6 air pump insulators.