Home › ENGINE ยท 1UR-FE › ENGINE CONTROL SYSTEM › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here


CAUTION:
  1. Wear protective gloves when removing the exhaust pipe assembly.
  2. The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe assembly has cooled down before removing it.



1. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(Click here)


2. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    A215441E01
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010  



3. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
  1. Remove the 3 nuts.

  1. Disconnect the exhaust pipe support to remove the front No. 2 exhaust pipe assembly.

  1. Remove the gasket.



4. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
  1. Disconnect the air fuel ratio sensor connector.



    A215438E01
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010