Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

for Preparation Click here


INSPECTION PROCEDURE

NOTICE:
Some satellite radio broadcast require payment. A contract must be made between a satellite radio company and the user. If the contract expires, the broadcast will not be able to be listened to or viewed.

1.CHECK NAVIGATION RECEIVER ASSEMBLY
  1. Check the radio condition.

    OK:
    Broadcast can be selected, but selection cannot be memorized.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
A


2.CHECK SATELLITE RADIO
  1. Check the number of preset channels.

    OK:
    36 channels have already been preset.



NG
Go to step 3
OK

END (ONLY 36 CHANNELS CAN BE PRESET) 

3.CHECK BATTERY
  1. Check if the battery was replaced.

    OK:
    Battery was not replaced.

    Result 
    Result
    Proceed to
    OK (for Column Shift Type)
    A
    OK (for Floor Shift Type)
    B
    NG
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
Go to step 4
A

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)  

4.ADD PRESET CHANNEL INTO MEMORY AGAIN
  1. Check if the preset channels that have been cleared can be added into memory again.

    OK:
    Preset channels can be added into memory.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END