Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

DTC    B1551    HD Radio Tuner Malfunction

DTC    B15A0    LAN Master Malfunction

DTC    B15AD    Navigation Processor Malfunction

DTC    B15B0    Display Screen Malfunction

DTC    B15B3    Radio Tuner Malfunction

DTC    B15B4    CD Changer Malfunction

DTC    B15B7    Bluetooth Module Malfunction

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation receiver assembly.

DTC Code
DTC Detection Condition
Trouble Area
B1551
When one of the conditions below is met:
  1. "HD Radio" tuner decoder malfunction
  2. "HD Radio" tuner audio output section malfunction
  3. "HD Radio" tuner decoder RF/IF malfunction
Navigation receiver assembly
B15A0
When either of the conditions below is met:
  1. Bus malfunction
  2. EEPROM error
B15AD
When one of the conditions below is met:
  1. Short to ground or +B, or open occurs in gyro signal circuit
  2. Gyro sensor malfunction
  3. GPS receiver malfunction
B15B0
Picture circuit (TFT unit) malfunction
B15B3
When one of the conditions below is met:
  1. AM tuner PLL is unlocked
  2. FM tuner PLL is unlocked
  3. Tuner malfunction
B15B4
When one of the conditions below is met:
  1. Mechanical communication error
  2. Load/Eject malfunction
  3. Read malfunction
  4. Mechanical malfunction
B15B7
"Bluetooth" module malfunction

INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    No DTCs are output.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)