Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

DTC    B15F8    D-Seat ECU Vehicle Information Reading/Writing Process Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when items controlled by the position control ECU and switch assembly cannot be customized via the audio and visual system vehicle customization screen.

HINT:
The position control ECU and switch assembly controls the front power seat control system related items that are customizable via the radio and display receiver assembly screen.


DTC Code
DTC Detection Condition
Trouble Area
B15F8
Position control ECU and switch assembly vehicle setting processing error.
  1. CAN communication system
  2. Front power seat control system (w/ Memory)
  3. Position control ECU and switch assembly
  4. Radio and display receiver assembly

INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Use the Techstream to check if the CAN communication system is functioning normally (Click here).

    OK:
    CAN communication system DTCs are not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.CHECK FRONT POWER SEAT CONTROL SYSTEM
  1. Check if the front power seat control system is malfunctioning (Click here).

    HINT:
    Customization may not be possible depending on the malfunction in the front power seat control system (w/ Memory).

    OK:
    No malfunctions are present in the front power seat control system (w/ Memory).



NG
GO TO FRONT POWER SEAT CONTROL SYSTEM (w/ Memory) (Click here)
OK


3.CHECK CUSTOMIZE ITEMS
  1. Display the "Vehicle Customization" screen.

  1. Make a note of the customizable items for each position control ECU assembly related system.

    HINT:
    These items shown as customizable via the radio and display receiver assembly vehicle customization screen can also be changed using the Techstream. In a following step, the Techstream will be used.

    1. Check the customize parameters list for the front power seat control system (w/ Memory) related items that can be customized via the radio and display receiver assembly screen (Click here).

  1. Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the radio and display receiver assembly screen.

    OK:
    The items available for customization via the radio and display receiver assembly screen can be customized successfully using the manual procedure.

    Result 
    Result
    Proceed to
    OK (for Column Shift Type)
    A
    OK (for Floor Shift Type)
    B
    NG
    C



B
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)

C
REPLACE POSITION CONTROL ECU AND SWITCH ASSEMBLY (Click here)
A

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)