NAVIGATION SYSTEM > USB Audio System Recognition/Play Error |

| 1.CHECK USB DEVICE OR "iPod" |
Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
Check if playable files are present on the USB device or "iPod".
Check if the USB device is a compatible format or "iPod" is a compatible version.
| Result | Proceed to |
| No playable files exist, or incompatible device format or version | A |
| Playable files exist, and compatible device format or version | B |
|
| ||||
| A | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the J116 navigation receiver assembly connector.
Disconnect the J100 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J116-1 (USV1) - J100-1 (UPI) | Always | Below 1 Ω |
| J116-2 (US1-) - J100-2 (UDO-) | Always | Below 1 Ω |
| J116-3 (US1+) - J100-3 (UDO+) | Always | Below 1 Ω |
| J116-4 (UGD1) - J100-4 (UJSG) | Always | Below 1 Ω |
| J116-5 (USG1) - J100-5 (UJSS) | Always | Below 1 Ω |
| J116-1 (USV1) - Body ground | Always | 10 kΩ or higher |
| J116-2 (US1-) - Body ground | Always | 10 kΩ or higher |
| J116-3 (US1+) - Body ground | Always | 10 kΩ or higher |
| J116-4 (UGD1) - Body ground | Always | 10 kΩ or higher |
| J116-5 (USG1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT NAVIGATION RECEIVER ASSEMBLY |
![]() |
Reconnect the J116 navigation receiver assembly connector.
Disconnect the No. 1 stereo jack adapter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| J100-1 (UPI) - J100-4 (UJSG) | Ignition switch ACC | 4.5 to 5.5 V |
| *a | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
| Result | Proceed to |
| OK | A |
| NG (for Column Shift Type) | B |
| NG (for Floor Shift Type) | C |
|
| ||||
|
| ||||
| A | |
| 4.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK |
Delete all files in the USB device or "iPod" and format/ restore it.
Save the data again and check if it can be played on the in-vehicle device.
|
| ||||
| OK | ||
| ||
| 5.REPLACE USB DEVICE OR "iPod" |
Turn the ignition switch off.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
| NEXT | |
| 6.CHECK USB DEVICE OR "iPod" |
Check if USB device or "iPod" is recognized by navigation receiver, or if information such as track, artist and album names are displayed on screen.
|
| ||||
| OK | ||
| ||