AUDIO AND VISUAL SYSTEM > Stereo Component Amplifier Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J144-7 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J144-4 (+B) - Body ground | Always | 11 to 14 V |
| J144-3 (ACC) - Body ground | Ignition switch ACC | 11 to 14 V |
| *a | Front view of wire harness connector (to Stereo Component Amplifier Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY) |
Disconnect the J144 stereo component amplifier assembly connector.
Disconnect the J137 radio and display receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J144-9 (AMP) - J137-9 (AMP) | Always | Below 1 Ω |
| J144-9 (AMP) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||