Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

DTC    B1579    Voice Recognition Microphone Disconnected

for Preparation Click here


DESCRIPTION

The radio and display receiver assembly and roof console box assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.
This DTC is stored when a microphone connection detection signal line is disconnected.

DTC Code
DTC Detection Condition
Trouble Area
B1579
Telephone microphone signal is lost.
  1. Radio and display receiver assembly
  2. Roof console box assembly
  3. Telephone microphone assembly
  4. Harness or connector

WIRING DIAGRAM


E280091E06


INSPECTION PROCEDURE

1.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY


    E280108E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J139-18 (SGND) - Body ground
    Always
    Below 1 Ω
    J139-19 (MIN-) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J139-4 (MACC) - Body ground
    Ignition switch ACC
    4 to 6 V

    Text in Illustration 
    *a
    Component with harness connected
    (Radio and Display Receiver Assembly)

Result 
Result
Proceed to
OK
A
NG (for Column Shift Type)
B
NG (for Floor Shift Type)
C


B
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)

C
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
A


2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY)
  1. Disconnect the J139 radio and display receiver assembly connector.

  1. Disconnect the W7 roof console box assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J139-4 (MACC) - W7-10 (ACC)
    Always
    Below 1 Ω
    J139-5 (MIN+) - W7-9 (MI1+)
    Always
    Below 1 Ω
    J139-19 (MIN-) - W7-8 (MIC-)
    Always
    Below 1 Ω
    J139-6 (SNS2) - W7-14 (SGND)
    Always
    Below 1 Ω
    J139-4 (MACC) - Body ground
    Always
    10 kΩ or higher
    J139-5 (MIN+) - Body ground
    Always
    10 kΩ or higher
    J139-19 (MIN-) - Body ground
    Always
    10 kΩ or higher
    J139-18 (SGND) - Body ground
    Always
    10 kΩ or higher
    J139-6 (SNS2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK TELEPHONE MICROPHONE ASSEMBLY
  1. Replace the telephone microphone assembly with a known good one (Click here).

  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    No DTCs are output.



NG
REPLACE ROOF CONSOLE BOX ASSEMBLY (Click here)
OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)