Home › DRIVE LINE › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM

TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure listed to troubleshoot the touch select 2-4 and high-low system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.

      NEXT


      4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
      1. Use the Techstream to check if the CAN communication system is functioning normally (Click here).

        HINT:
        The ECU of this system is connected to the CAN communication system.
        Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.


        Result 
        Result
        Proceed to
        CAN DTCs are not output
        A
        CAN DTCs are output
        B



      B.
      GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
      A


      5.CHECK DTC*
      1. Check for DTCs (Click here).

        1. Record the DTCs.

      2. Clear the DTCs (Click here).

      3. Recheck for DTCs (Click here).

        1. Simulate the malfunction condition and check if the DTCs are output again.

          Result 
          Result
          Proceed to
          DTCs are not output
          A
          DTCs are output
          B



      B.
      GO TO STEP 10
      A


      6.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table.

        Result 
        Result
        Proceed to
        Fault not listed in problem symptoms table
        A
        Fault listed in problem symptoms table
        B



      B.
      GO TO STEP 8
      A


      7.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. Terminals of ECU (Click here).


      NEXT


      8.REPAIR OR REPLACE

        NEXT


        9.CONFIRM TEST

          NEXT

          END


          10.GO TO DTC CHART

            NEXT

            GO TO STEP 8