Home › DRIVE LINE › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM

DTC    P0560    System Voltage

for Preparation Click here


DESCRIPTION

This DTC is detected when the 4 wheel drive control ECU, which monitors the B terminal voltage, determines that the standard voltage is not met and detects a B terminal system malfunction.

DTC Code
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
P0560
  1. The ignition switch is ON and the transfer position switch is operated
  2. Open circuit or short to ground in the B terminal system (B terminal voltage is below 9.5 V)
  3. 1 second or more
  4. 1 trip detection logic
  1. Battery
  2. Charging system
  3. Wire harness and connector
  4. 4 wheel drive control ECU

WIRING DIAGRAM


C291309E01


INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  2. If only past DTCs are output, battery depletion may have occurred in the past.

1.INSPECT BATTERY
  1. Inspect the battery (3UR-FE: Click here, 3UR-FBE: Click here, 1UR-FE: Click here).



NG
REPLACE BATTERY
OK


2.CHECK BATTERY TERMINAL
  1. Check the battery terminals (3UR-FE: Click here, 3UR-FBE: Click here, 1UR-FE: Click here).



NG
REPAIR BATTERY TERMINAL OR REPLACE BATTERY
OK


3.CHECK HARNESS AND CONNECTOR (B TERMINAL)


    B156389E10
  1. Disconnect the 4 wheel drive control ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A25-6 (B) - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to 4 Wheel Drive Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (GND TERMINAL)
B156389E11
  1. Disconnect the 4 wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A25-5 (GND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to 4 Wheel Drive Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Operate the transfer position switch.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
CHECK INTERMITTENT PROBLEMS (Click here)
A

REPLACE 4 WHEEL DRIVE CONTROL ECU (Click here)