Home › DRIVE LINE › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM

DTC    P17A0    Automatic Disconnecting Differential Motor Control Circuit Open

DTC    P17A1    Automatic Disconnecting Differential Motor Control Circuit Low

for Preparation Click here


DESCRIPTION

This DTC is detected when an open circuit or short to ground in the A.D.D. shift motor drive circuit is detected.

DTC Code
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
P17A0
  1. Ignition switch ON (when not switching between 2WD and 4H)
  2. Open circuit in the A.D.D. shift motor drive circuit
  3. 1 second or more
  4. 1 trip detection logic
  1. Wire harness and connector
  2. 4 wheel drive control ECU
  3. A.D.D. actuator (differential vacuum actuator assembly)
P17A1
  1. Ignition switch ON (when not switching between 2WD and 4H)
  2. Short to ground in the A.D.D. shift motor drive circuit
  3. 1 second or more
  4. 1 trip detection logic
  1. Wire harness and connector
  2. 4 wheel drive control ECU
  3. A.D.D. actuator (differential vacuum actuator assembly)

WIRING DIAGRAM


C290925E01


INSPECTION PROCEDURE

1.CHECK DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY (A.D.D. SHIFT MOTOR)
B156389E08
  1. Disconnect the 4 wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A25-1 (DM1) - A25-2 (DM2)
    Always
    2 Ω or less
    A25-1 (DM1) or A25-2 (DM2) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to 4 Wheel Drive Control ECU)



NG
Go to step 2
OK

REPLACE 4 WHEEL DRIVE CONTROL ECU (Click here)  

2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY)
  1. Disconnect the A25 4 wheel drive control ECU connector.

  1. Disconnect the G1 A.D.D. actuator (differential vacuum actuator assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A25-1 (DM1) - G1-1 (DM1)
    Always
    Below 1 Ω
    A25-2 (DM2) - G1-2 (DM2)
    Always
    Below 1 Ω
    A25-1 (DM1) or G1-1 (DM1) - Body ground
    Always
    10 kΩ or higher
    A25-2 (DM2) or G1-2 (DM2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY (Click here)