DTC P17A2 Automatic Disconnecting Differential Motor Control Circuit High |
| DTC Code | DTC Detection Condition
| Trouble Area |
| P17A2 |
|
|
| 1.CHECK DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY (A.D.D. SHIFT MOTOR) |
![]() |
Disconnect the 4 wheel drive control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A25-1 (DM1) or A25-2 (DM2) - Body ground | Ignition switch ON | Below 1 V |
| *a | Front view of wire harness connector (to 4 Wheel Drive Control ECU) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU AND DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY - BODY GROUND) |
Disconnect the A25 4 wheel drive control ECU connector.
Disconnect the G1 A.D.D. actuator (differential vacuum actuator assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A25-1 (DM1) or G1-1 (DM1) - Body ground | Ignition switch ON | Below 1 V |
| A25-2 (DM2) or G1-2 (DM2) - Body ground | Ignition switch ON | Below 1 V |
|
| ||||
| OK | ||
| ||