Home › DRIVE LINE › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM

DTC    P17A4    Automatic Disconnecting Differential Motor Limit Switch Circuit

for Preparation Click here


DESCRIPTION

When the A.D.D. actuator is switching between 2WD and 4WD, the DL1 and DL2 terminals of the limit switch are in one of the ON/OFF combinations listed in the table below.

Terminal
In 2WD
Switching between 2WD and 4WD
In 4WD
DL1
OFF (OPEN)
ON (GND)
ON (GND)
DL2
ON (GND)
ON (GND)
OFF (OPEN)
This DTC is detected when the limit switch ON/OFF combination (2 lines) is abnormal.

DTC Code
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
P17A4
  1. Ignition switch is ON and engine is running
  2. Limit switch DL1 terminal is OFF (OPEN) and the DL2 terminal is OFF (OPEN)
  3. 1 second or more
  4. 1 trip detection logic
  1. Wire harness and connector
  2. 4 wheel drive control ECU
  3. A.D.D. actuator (differential vacuum actuator assembly)

WIRING DIAGRAM


C290926E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY)
  1. Disconnect the A25 4 wheel drive control ECU connector.

  1. Disconnect the G1 A.D.D. actuator (differential vacuum actuator assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A25-7 (DL1) - G1-6 (DL1)
    Always
    Below 1 Ω
    A25-20 (DL2) - G1-5 (DL2)
    Always
    Below 1 Ω
    G1-4 (GND) - Body ground
    Always
    Below 1 Ω
    A25-7 (DL1) or G1-6 (DL1) - Body ground
    Always
    10 kΩ or higher
    A25-20 (DL2) or G1-5 (DL2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY (LIMIT SWITCH)
C290971E02
  1. Disconnect the G1 A.D.D. actuator (differential vacuum actuator assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    6 (DL1) - Body ground
    Always
    10 kΩ or higher
    5 (DL2) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (A.D.D. Actuator [Differential Vacuum Actuator Assembly])



NG
REPLACE 4 WHEEL DRIVE CONTROL ECU (Click here)
OK

REPLACE DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY (Click here)