Home › DRIVE LINE › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM

DTC    P279E    Four Wheel Drive (4WD) Range Signal Circuit Range / Performance

for Preparation Click here


DESCRIPTION

This DTC is detected if the transfer position switch 2-4 terminal and LO terminal signals are simultaneously received.

DTC Code
DTC Detection Condition
  1. Diagnosis Condition
  2. Malfunction Status
  3. Malfunction Time
  4. Other
Trouble Area
P279E
  1. Ignition switch is ON and engine is running
  2. 2-4 terminal signal is OFF (OPEN) and LO terminal signal is OFF (OPEN)
  3. 60 seconds or more
  4. 1 trip detection logic
  1. Wire harness and connector
  2. 4 wheel drive control ECU
  3. Transfer position switch

WIRING DIAGRAM


C290930E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - TRANSFER POSITION SWITCH)
  1. Disconnect the A25 4 wheel drive control ECU connector.

  1. Disconnect the J129 transfer position switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A25-12 (2-4) - J129-2 (2-4)
    Always
    Below 1 Ω
    A25-11 (LO) - J129-3 (LO)
    Always
    Below 1 Ω
    J129-5 (GND) - Body ground
    Always
    Below 1 Ω
    A25-12 (2-4) or J129-2 (2-4) - Body ground
    Always
    10 kΩ or higher
    A25-11 (LO) or J129-3 (LO) - Body ground
    Always
    10 kΩ or higher
    A25-12 (2-4) or J129-2 (2-4) - A25-11 (LO) or J129-3 (LO)
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK TRANSFER POSITION SWITCH
C291352E01
  1. Remove the transfer position switch with its connector still connected (Click here).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J129-2 (2-4) - Body ground
    Ignition switch ON
    2WD position
    Below 1 V
    Ignition switch ON
    4H position
    Below 1.5 V
    Ignition switch ON
    4L position
    10.5 to 14 V
    J129-3 (LO) - Body ground
    Ignition switch ON
    2WD position
    10.5 to 14 V
    Ignition switch ON
    4H position
    Below 1.5 V
    Ignition switch ON
    4L position
    Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Transfer Position Switch)



NG
REPLACE TRANSFER POSITION SWITCH (Click here)
OK

REPLACE 4 WHEEL DRIVE CONTROL ECU (Click here)