Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Data Signal Circuit between Navigation Receiver Assembly and Extension Module

for Preparation Click here


DESCRIPTION

The stereo component tuner assembly sends the sound data signal or image data signal from a device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM


E282848E06


INSPECTION PROCEDURE

NOTICE:
After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT TUNER ASSEMBLY)
  1. Disconnect the K1 and L1 navigation receiver assembly connectors.

  1. Disconnect the K2 and L3 stereo component tuner assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K1-1 (USV4) - K2-1 (USV4)
    Always
    Below 1 Ω
    K1-2 (US4-) - K2-2 (US4-)
    Always
    Below 1 Ω
    K1-3 (US4+) - K2-3 (US4+)
    Always
    Below 1 Ω
    K1-4 (UGD4) - K2-4 (UGD4)
    Always
    Below 1 Ω
    K1-5 (USG4) - K2-5 (USG4)
    Always
    Below 1 Ω
    L1-4 (+B2) - L3-4 (+B2)
    Always
    Below 1 Ω
    L1-3 (ACC2) - L3-3 (ACC2)
    Always
    Below 1 Ω
    L1-8 (GND2) - L3-8 (GND2)
    Always
    Below 1 Ω
    K1-1 (USV4) - Body ground
    Always
    10 kΩ or higher
    K1-2 (US4-) - Body ground
    Always
    10 kΩ or higher
    K1-3 (US4+) - Body ground
    Always
    10 kΩ or higher
    K1-4 (UGD4) - Body ground
    Always
    10 kΩ or higher
    K1-5 (USG4) - Body ground
    Always
    10 kΩ or higher
    L1-4 (+B2) - Body ground
    Always
    10 kΩ or higher
    L1-3 (ACC2) - Body ground
    Always
    10 kΩ or higher
    L1-8 (GND2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK NO. 1 NAVIGATION WIRE
  1. Replace the No. 1 navigation wire with a known good one.
    for Column Shift Type: Click here
    for Floor Shift Type: Click here

  1. Check that the malfunction disappears.

    OK:
    Malfunction disappears.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (NO. 1 NAVIGATION WIRE IS DEFECTIVE)