Home › DRIVE LINE › WF1AM TRANSFER › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM

TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM > 4WD Control Switch Circuit

for Preparation Click here


WIRING DIAGRAM


C293135E01


INSPECTION PROCEDURE

1.CONFIRM PROBLEM SYMPTOM
  1. Confirm the problem symptoms.

    Result 
    Result
    Proceed to
    The 4HI and 4LO indicator lights are not illuminated
    A
    The 4HI indicator light is illuminated and the 4LO indicator light is not illuminated
    B
    The 4HI indicator light is not illuminated and the 4LO indicator light is illuminated
    C



B
Go to step 5

C
Go to step 6
A


2.CHECK 4HI INDICATOR LIGHT
  1. Turn the ignition switch to ON.

  1. Move the shift lever to N.

  1. Turn the transfer position switch to 4H.

  1. Check the 4HI indicator light.

    Result 
    Result
    Proceed to
    The 4HI indicator light is blinking or illuminated
    A
    The 4HI indicator light is not illuminated
    B



B
Go to step 3
A

END 

3.CHECK FOR DTC
  1. Turn the transfer position switch to 4L.

  1. Check if DTC P279E is output after 60 seconds elapse (Click here).


Result 
Result
Proceed to
DTC P279E is not output
A
DTC P279E is output
B


B
REPAIR CIRCUIT INDICATED BY OUTPUT CODE (Click here)
A


4.CHECK CAN COMMUNICATION LINE
  1. Select "Bus Check" from the System Selection Menu screen, and follow the prompts on the screen to inspect the CAN Bus (Click here).

    OK:
    "Bus Check" indicates no malfunctions in CAN communication.



NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)  

5.CHECK 4HI INDICATOR LIGHT
  1. Turn the ignition switch to ON.

  1. Move the shift lever to N.

  1. Turn the transfer position switch to 2WD.

  1. Turn the transfer position switch to 2WD.

    Result 
    Result
    Proceed to
    The 4HI indicator light is blinking or not illuminated
    A
    The 4HI indicator light is illuminated
    B



B
GO TO DTC P279E (Click here)
A

END 

6.CHECK 4LO INDICATOR LIGHT
  1. Turn the ignition switch to ON.

  1. Move the shift lever to N.

  1. Turn the transfer position switch to 4H.

  1. Check the 4LO indicator light.

    Result 
    Result
    Proceed to
    The 4LO indicator light is blinking or not illuminated
    A
    The 4LO indicator light is illuminated
    B



B
Go to step 7
A

END 

7.CHECK FOR DTC
  1. Turn the transfer position switch to 2WD.

  1. Check if DTC P279E is output after 60 seconds elapse (Click here).

    Result 
    Result
    Proceed to
    DTC P279E is not output
    A
    DTC P279E is output
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT CODE (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)