Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.
Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.
Wipe off the remaining double-sided tape using a clean cloth or equivalent.
If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.
After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.
The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.
FRONT FENDER PLATE LH
| *a | Reference Values | - | - |
DOOR NAME PLATE LH
| *A | for LH Side | *B | for RH Side |
| *a | Reference Values | - | - |
ROOF SIDE NO. 1 MARK LH
for Regular Cab:
| *A | for LH Side | *B | for RH Side |
| *a | Reference Values | - | - |
for Double Cab:
| *A | for LH Side | *B | for RH Side |
| *a | Reference Values | - | - |
for CrewMax:
| *A | for LH Side | *B | for RH Side |
| *a | Reference Values | - | - |
REAR BODY NO. 3 NAME PLATE (for 4WD)
| *a | Reference Values |
REAR BODY STRIPE LH
| *A | for 2WD | *B | for 4WD |
| *a | Rear End of Character Line | - | - |