Home › Vehicle Exterior › BODY WELD POINT › ROCKER OUTER PANEL
BM27M0U _01 Vehicle Exterior _049435 BODY WELD POINT _0236698 ROCKER OUTER PANEL F

BODY WELD POINT  ROCKER OUTER PANEL  CUT AND JOIN REPLACEMENT SECTIONS (LARGE AREAS)  


Regular Cab


K125894

a.

REMOVAL / INSTALLATION

Symbol Meaning
K108818

Remove Weld Points
K108828

Cut Location for Supply Parts
K108823

Plug Weld
K108831

Butt Weld

INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

After welding, apply undercoating to the corresponding parts. (See the painting / coating)

4.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K125948



Double Cab


K125895

a.

REMOVAL / INSTALLATION

Symbol Meaning
K108818

Remove Weld Points
K108827

Cut and Join Location
K108828

Cut Location for Supply Parts
K108823

Plug Weld
K108831

Butt Weld

INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

After welding, apply undercoating to the corresponding parts. (See the painting / coating)

4.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K125949C01
6.594,8.51 6.906,8.667 0.313,0.156 10 false *a 5.177,2.229 6.229,2.417 1.052,0.188 10 false 450 (17.72)
*a mm (in.) - -




CrewMax


K125896

a.

REMOVAL / INSTALLATION

Symbol Meaning
K108818

Remove Weld Points
K108827

Cut and Join Location
K108828

Cut Location for Supply Parts
K108823

Plug Weld
K108831

Butt Weld

INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

After welding, apply undercoating to the corresponding parts. (See the painting / coating)

4.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K125950C01
6.719,8.573 7.031,8.729 0.313,0.156 10 false *a 4.677,2.167 5.5,2.396 0.823,0.229 10 false 450 (17.72)
*a mm (in.) - -