General
The cooling system uses a pressurized forced circulation system with an open air type reservoir tank.
An engine coolant distribution pathway is provided between the left and right banks of the cylinder block.
A thermostat with a bypass valve is located on the plastic water inlet to maintain suitable temperature distribution in the cooling system.
An aluminum radiator core is used for weight reduction.
A 2-stage temperature-controlled coupling fan is used. It rotates at lower speeds when the engine is cold to minimize fan noise.
Toyota Genuine Super Long Life Coolant (SLLC) is used as the engine coolant.
| *1 | Throttle Body | *2 | Thermostat |
| *3 | Radiator | *4 | Water Pump |
| *a | To Heater Radiator | *b | From Heater Radiator |
| *1 | Radiator Reservoir Tank | *2 | EGR Valve |
| *3 | Radiator | *4 | Water Pump |
| *5 | Thermostat | *6 | Cylinder Block |
| *7 | Cylinder Block Water Jacket Spacer | *8 | Water Jacket |
| *9 | Cylinder Head | *10 | Engine Coolant Distribution Pathway |
| *11 | EGR Cooler | *12 | Heater Radiator |
| *13 | Transmission Oil Cooler (Warmer) | *14 | Throttle Body |
|
SLLC is pre-mixed (models for U.S.A. : 50% coolant and 50% deionized water, models for Canada: 55% coolant and 45% deionized water). Therefore, no dilution is needed when SLLC in the vehicle is added to or replaced. |
||
| Engine Coolant Type | Toyota Genuine Super Long Life Coolant (SLLC) or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite and non-borate coolant with long-life hybrid organic acid technology (coolant with long-life hybrid organic acid technology is a combination of low phosphates and organic acids). Do not use plain water alone. | |
| Color | Pink | |
| Maintenance Intervals | First Time | 100000 miles (160000 km) |
| Subsequent | Every 50000 miles (80000 km) | |
| Thermostat | Opening Temperature | 80°C to 84°C (176°F to 183°F) |
Water Pump
A rust-resistant water pump rotor made of stainless steel is used.
The water pump circulates the engine coolant to the engine coolant distribution pathway located between the left and right banks of the cylinder block.
| *1 | Water Pump | *2 | Water Pump Gasket |
| *3 | Timing Chain Cover | *4 | Rotor |
| *a | Back Side View | *b | From Water Inlet Housing |
Engine Coolant Distribution Pathway
The water pump circulates the engine coolant and directs it to the engine coolant distribution pathway located between the left and right banks. From there, the engine coolant is uniformly distributed to each cylinder of the cylinder block, and is also directly discharged to the cylinder heads. As a result, the cooling performance of the cylinder heads is assured and reliability is improved.
| *1 | Heat Exchanger Cover | *2 | Cylinder Block |
| *a | From Water Pump | *b | Front Side |
| *c | To Cylinder Head | *d | Engine Coolant Distribution Pathway |
| *e | Engine Coolant Flow | - | - |