General
A fuel cut control is used to stop the fuel pump when SRS airbags deploy in a frontal or side collision.
Compact 12-hole type fuel injectors are used to improve the atomization of fuel.
Quick connectors are used to connect the fuel lines for ease of serviceability.
A multi-layer plastic fuel tank is used.
An evaporative emission control system is used.
| *1 | Fuel Delivery Pipe | *2 | Fuel Pressure Regulator |
| *3 | Fuel Injector | *4 | Pulsation Damper |
| *5 | Quick Connector | *6 | Fuel Tank |
| *7 | Fuel Pump Assembly
·
Fuel Pump ·
Fuel Filter ·
Fuel Sender Gauge |
*8 | Charcoal Canister Assembly |
Fuel Injector
A 12-hole fuel injector with optimized fuel flow amount is used to improve the atomization of fuel.
| *a | Bottom Side View | *b | Fuel Injector Cross Section |
Delivery Pipe
Fuel delivery pipes formed from stamped steel are used to deliver fuel to the fuel injectors.
A pulsation damper is provided on the fuel delivery pipe in the left bank. A fuel pressure regulator is installed on the right bank fuel delivery pipe.
| *1 | Fuel Pressure Regulator | *2 | Fuel Delivery Pipe |
| *3 | Pulsation Damper | - | - |