Home › General › BODY ELECTRICAL › SEAT BELT REMINDER SYSTEM
NM27M0U _V1 General _050233 BODY ELECTRICAL _0246069 SEAT BELT REMINDER SYSTEM UN GENERAL/CONTROL/DETAILS F

BODY ELECTRICAL  SEAT BELT REMINDER SYSTEM  GENERAL/CONTROL/DETAILS  DESCRIPTION  


DESCRIPTION


a.

If a seat belt is not fastened, this system flashes the seat belt reminder light or sounds the buzzer in the combination meter as a reminder.

i.

The seat belt reminder buzzer for the front passenger can be cancelled. However, the legally mandated minimum operation of the buzzer cannot be cancelled.


ii.

When the ignition switch is turned to the ON position, this system detects the condition of the seat belts based on the signals indicated below.

Seat Base Signal Reminder Method
Driver Seat Belt Buckle Switch (Contact Type)
·

Buzzer sounds

·

Reminder light flashes


Front Passenger
·

Seat Belt Buckle Switch (Non-contact Type)

·

Four Occupant Classification Sensors (Though the Occupant Classification ECU)


·

Buzzer sounds

·

Reminder light flashes



HINT:

Buzzer reminder cancel mode can be set using a hand-held tester or Techstream*. For details, refer to the Repair Manual.

*: Techstream is the name for the diagnostic tester in North America, but other countries will continue to use the hand-held tester.