General
Effective application of vibration damping and noise suppressing materials reduce engine and road noise.
Body Mounts
Using the following structures, rigidity at the installation area of the body mounts is increased to reduce vibration that is transmitted to the body.
No. 2 body mounts are located directly under the dash panel and use flanged collars.
No. 3 body mounts are located directly under the back panel, they use flanged collars, and the attaching surfaces are minimized.
| *1 | No. 2 Body Mount | *2 | No. 3 Body Mount |
| *3 | Dash Panel | *4 | Flanged Collar |
| *5 | Back Panel | - | - |
| *a | Attaching Surface | - | - |
Under Body
Floor cross members and longitudinal members are optimally arranged to reduce floor vibration.
A damping coating is used to the reduction of the weight, noise, and vibration.
| *a | Floor Cross Member | *b | Damping Coating |
| *c | Front | - | - |
Dash Panel
A sound-absorbing type insulator is used as the dash insulator to reduce engine noise transmitted to the cabin.
| *1 | Dash Panel | *2 | Dash Insulator |
| *a | Front | - | - |
Hood Panel
A hood insulator has been added to the backside of the hood panel, reducing engine noise.
| *1 | Hood Insulator | - | - |
| *a | A - A Cross Section | - | - |
Door Trim
Silencer pads are installed on the door trim, which helps prevent noise from entering.
| *1 | Hood Insulator | - | - |
Rear Deck Fender Liner
A rear deck fender liner is installed to reduce low noise and improve appearance.
| *1 | Rear Deck Fender Liner | - | - |