Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › FUEL PUMP RELAY
RM27M0U _51 Engine / Hybrid System _049094 3UR-FE ENGINE CONTROL _0233920 FUEL PUMP RELAY G

3UR-FE ENGINE CONTROL  FUEL PUMP RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.REMOVE FUEL PUMP RELAY (F/PMP)

a.

Remove the fuel pump relay from the engine room relay block.


Hide 2.INSPECT FUEL PUMP RELAY

A372781E01
2,0.573 1.802,0.25 false 2.615,0.563 2.813,0.24 false 2.51,1.104 2.938,1.104 false 2.531,1.604 2.958,1.604 false 1.677,0.125 1.833,0.323 0.156,0.198 10 false 1 2.854,0.094 3.01,0.292 0.156,0.198 10 false 2 2.99,1.01 3.146,1.208 0.156,0.198 10 false 5 3.01,1.5 3.167,1.698 0.156,0.198 10 false 3 0.219,1.292 0.375,1.49 0.156,0.198 10 false 2 0.219,0.76 0.375,0.958 0.156,0.198 10 false 3 1.198,0.75 1.354,0.948 0.156,0.198 10 false 5 1.188,1.313 1.344,1.51 0.156,0.198 10 false 1

a.

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
3 - 5 When no battery voltage is applied to terminals 1 and 2 10 kΩ or higher
When battery voltage is applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the relay.


Hide 3.INSTALL FUEL PUMP RELAY