Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM27M0U _51 Engine / Hybrid System _049094 3UR-FE ENGINE CONTROL _0233922 ACCELERATOR PEDAL G

3UR-FE ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ACCELERATOR PEDAL ROD ASSEMBLY

a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Push the Techstream main switch ON.


d.

Enter the following menus:

Select: Powertrain / Engine and ECT / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.


e.

Read the value displayed on the tester.

Accel Sensor Out No. 1:
Standard voltage
Condition Specified Condition
Accelerator pedal is released 0.5 to 1.1 V
Accelerator pedal is depressed 2.6 to 4.5 V


Accel Sensor Out No. 2 :
Standard voltage
Condition Specified Condition
Accelerator pedal is released 1.2 to 2.0 V
Accelerator pedal is depressed 3.4 to 5.0 V


If the result is not as specified, check the accelerator pedal rod, wire harness or ECM.