Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM27M0U _51 Engine / Hybrid System _049094 3UR-FE ENGINE CONTROL _0233924 HEATED OXYGEN SENSOR G

3UR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89465 1.CHECK HEATED OXYGEN SENSOR

a.

Disconnect the sensor connector.


b.
A379741E01
1.875,1.875 2.188,1.448 2.188,1.448 2.344,1.448 true 1.344,1.896 1.167,1.458 1.167,1.458 0.99,1.458 true 0.208,0.156 2.677,0.5 2.469,0.344 10 false Component without harness connected: (Heated Oxygen Sensor) 2.406,1.25 2.979,1.427 0.573,0.177 10 false HT1B*1 2.406,1.427 2.979,1.604 0.573,0.177 10 false HT2B*2 0.729,1.365 1.01,1.563 0.281,0.198 10 false +B 0.156,2.656 1.146,2.854 0.99,0.198 10 false *1: for Bank 1 0.146,2.969 1.135,3.167 0.99,0.198 10 false *2: for Bank 2

Measure the heater resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
1 (HT1B) - 2 (+B)
(for Bank 1)
20°C (68°F) 11 to 16 Ω
1 (HT2B) - 2 (+B)
(for Bank 2)


If the result is not as specified, replace the sensor.


c.

Reconnect the sensor connector.