Home › Engine / Hybrid System › 3UR-FBE ENGINE CONTROL › CIRCUIT OPENING RELAY
RM27M0U _51 Engine / Hybrid System _049095 3UR-FBE ENGINE CONTROL _0233942 CIRCUIT OPENING RELAY G

3UR-FBE ENGINE CONTROL  CIRCUIT OPENING RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.REMOVE CIRCUIT OPENING RELAY (C/OPN)

a.

Remove the circuit opening relay from the engine room relay block.


Hide 2.INSPECT CIRCUIT OPENING RELAY

a.
A111813E27
2.823,1.073 3.146,1.073 false 2.083,1.083 1.833,1.083 false 2.49,1.438 2.49,1.792 false 2.458,0.719 2.615,0.302 2.615,0.302 2.75,0.302 false 2.792,0.198 2.906,0.354 0.115,0.156 10 false 1 1.323,1.177 1.479,1.344 0.156,0.167 10 false 1 1.688,1.01 1.844,1.177 0.156,0.167 10 false 3 0.365,0.781 0.521,0.948 0.156,0.167 10 false 3 2.448,1.781 2.604,1.948 0.156,0.167 10 false 2 0.365,1.177 0.521,1.344 0.156,0.167 10 false 2 3.208,0.969 3.365,1.135 0.156,0.167 10 false 5 1.323,0.781 1.479,0.948 0.156,0.167 10 false 5

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 When no battery voltage is applied to terminals 1 and 2 10 kΩ or higher
When battery voltage is applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the relay.


Hide 3.INSTALL CIRCUIT OPENING RELAY