Home › Engine / Hybrid System › 3UR-FBE FUEL › FUEL INJECTOR
RM27M0U _51 Engine / Hybrid System _049096 3UR-FBE FUEL _0233949 FUEL INJECTOR G

3UR-FBE FUEL  FUEL INJECTOR  INSPECTION  


PROCEDURE

Hide 23250 1.INSPECT FUEL INJECTOR ASSEMBLY

a.
A158970E10
0.385,0.438 3.01,0.896 2.625,0.458 10 false Component without harness connected: (Fuel Injector)

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 11.6 to 12.4 Ω


If the result is not as specified, replace the injector assembly.


b.

Inspect the injection volume.

CAUTION:
·

This test involves high-pressure fuel and electricity. Take all precautions regarding safe handling of both the fuel and the electricity.

·

Perform this test in a safe area, and avoid any sparks or flames.

·

Do not smoke.



i.
A380110E01
1.229,0.875 1.073,0.198 1.073,0.198 0.938,0.198 false 0.313,0.104 0.969,0.49 0.656,0.385 10 false Fuel Pipe Clamp

Remove the fuel pipe clamp.


ii.

Disconnect the No. 1 fuel pipe sub-assembly (for quick type B) (See page Engine / Hybrid System>3UR-FBE FUEL>FUEL SYSTEM>PRECAUTION).


iii.
A273854E03
2.958,0.75 2.958,1.042 false 2.01,1.26 2.01,1.479 false 0.854,1.938 0.583,1.938 0.583,1.938 0.406,1.688 false 1.229,0.26 1.021,0.26 1.021,0.26 0.688,1.146 false 2.635,1.073 3.271,1.24 0.635,0.167 10 false Fuel Pipe 1.177,1.521 2.958,1.698 1.781,0.177 10 false SST (Fuel Tube Connector) 0.885,1.854 1.646,2.021 0.76,0.167 10 false SST (Hose) 1.281,0.177 2.417,0.365 1.135,0.188 10 false SST (Hose Band)

Connect SST to the fuel pipe (the vehicle side).

SST
09268-31014  (09268-41500, 09268-41700, 95336-08070)


iv.
A273855E01
0.032,0.159 1.155,0.345 1.123,0.186 10 SST (Hose Band) 2.551,1.401 3.235,1.581 0.684,0.180 10 SST (Clip) 0.617,1.115 1.095,1.307 0.478,0.193 10 O-Ring 0.534,1.75 0.902,1.931 0.368,0.180 10 Tube 2.196,0.392 3.122,0.568 0.926,0.176 10 SST (Adapter) 2.529,1.483 2.338,1.483 false 1.592,0.261 1.406,0.261 false 1.617,1.224 1.189,1.224 false 0.973,1.853 1.222,1.853 1.222,1.853 1.6,2.046 false 2.168,0.473 1.983,0.473 1.983,0.473 1.738,0.589 false

Install the O-ring to the fuel injector.


v.

Install SST and a tube to the fuel injector.

SST
09268-31014  (09268-41300, 09268-41500, 09268-41600, 09268-41700)

CAUTION:

Install a strong rubber tube onto the injector to prevent gasoline from splashing.



vi.
A273857E01
2.826,0.872 3.177,1.040 0.350,0.167 10 Lock 2.795,0.959 2.584,0.959 2.584,0.959 2.447,0.8 false 0.022,0.274 1.007,0.464 0.986,0.191 10 SST (Tie Band) 1.233,0.379 1.368,0.379 1.368,0.379 1.588,1.505 false

Pass SST (tie band) through the loop on the handle of SST (clamp) to secure SST (clamp) to SST (adapter).

SST
09268-31014  (09268-41800)

NOTICE:
·

As SST (tie band) does not completely prevent SST (clamp) from becoming loose, do not subject the parts to any impacts while using them.

·

Before using SST (tie band), make sure that there is no deterioration, damage or cracks. If there are any abnormalities, replace SST.



HINT:

When removing SST (tie band), disengage the lock.



vii.

Check that SST (clamp) and SST (adapter) cannot be easily separated.


viii.

Put the injector into a graduated cylinder.


ix.

Operate the fuel pump (turn the ignition switch to ON).


x.
A273856E01
1.407,1.731 2.148,1.938 0.740,0.206 10 SST (Wire) 1.757,0.339 1.757,1.712 false

Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.

SST
09842-30090  

Standard injection volume:

97 to 118 cm3 (5.9 to 7.2 cu. in.) per 15 seconds


Difference between each injector:

21 cm3 (1.3 cu. in.) or less


NOTICE:
·

Make sure that SST (EFI inspection wire I) is securely connected.


·

Always turn the voltage on and off on the battery side, not the fuel pump side.



If the injection volume is not as specified, replace the injector assembly.



c.

Check for leakage.

i.
A149194

In the condition above, disconnect the tester probes of SST (wire) from the battery and check for fuel leakage from the injector.

Standard:

1 drop or less in 12 minutes