Home › Engine / Hybrid System › 3UR-FBE EMISSION CONTROL › PURGE VALVE
RM27M0U _51 Engine / Hybrid System _049099 3UR-FBE EMISSION CONTROL _0233976 PURGE VALVE G

3UR-FBE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT PURGE VSV

A148341E09
0.594,0.771 0.458,1.25 false 0.76,0.792 0.917,1.271 false 1.156,3.396 0.698,2.927 false 1.208,3.417 1.656,3.229 false 0.885,1.281 1.042,1.448 0.156,0.167 10 false 1 0.406,1.271 0.563,1.438 0.156,0.167 10 false 2 1.698,3.135 1.854,3.302 0.156,0.167 10 false 1 0.542,2.823 0.698,2.99 0.156,0.167 10 false 2 2.5,2.063 3.198,2.219 0.698,0.156 10 false 23 to 26 Ω 2.198,4.063 3.208,4.25 1.01,0.188 10 false 10 kΩ or higher

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω
1 - VSV body ground Always 10 kΩ or higher
2 - VSV body ground 10 kΩ or higher


If the result is not as specified, replace the purge VSV.


b.
A148342E03
2.033,0.12 2.294,0.299 0.261,0.179 10 Air 0.238,1.79 1.212,1.969 0.974,0.179 10 Does not flow 1.364,0.703 1.520,0.883 0.157,0.179 10 E 1.076,1.434 1.233,1.613 0.157,0.179 10 F

Inspect the purge VSV operation.

i.

Check that air does not flow from ports.


ii.
A148343E01
1.666,0.113 1.896,0.269 0.230,0.156 10 Air 0.976,0.843 1.143,0.999 0.167,0.156 10 E 0.874,1.806 1.041,1.962 0.167,0.156 10 F

Apply battery voltage across the terminals.


iii.

Check that air flows from ports.

If the result is not as specified, replace the purge VSV.