Home › Engine / Hybrid System › 1UR-FE EMISSION CONTROL › PURGE VALVE
RM27M0U _51 Engine / Hybrid System _049101 1UR-FE EMISSION CONTROL _0233993 PURGE VALVE G

1UR-FE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT PURGE VSV

A148341E06
0.542,1.453 0.694,1.622 0.152,0.169 10 1 1.477,0.697 1.629,0.865 0.152,0.169 10 2 0.563,2.941 0.716,3.109 0.152,0.169 10 1 1.889,3.109 2.041,3.277 0.152,0.169 10 2 0.599,0.819 0.599,1.429 false 0.798,0.785 1.44,0.785 false 1.22,3.434 1.701,3.193 1.701,3.193 1.844,3.193 false 0.694,3.024 0.818,3.024 0.818,3.024 1.166,3.414 false

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω
1 - VSV body ground Always 10 MΩ or higher
2 - VSV body ground 10 MΩ or higher


If the result is not as specified, replace the purge VSV.


b.
A214835E01
2.053,0.107 2.320,0.337 0.267,0.230 10 Air 1.372,0.731 1.535,0.915 0.163,0.184 10 E 1.061,1.434 1.223,1.618 0.163,0.184 10 F

Inspect the purge VSV operation.

i.

Check that air does not flow from ports.


ii.
A148343E01
1.666,0.113 1.896,0.269 0.230,0.156 10 Air 0.976,0.843 1.143,0.999 0.167,0.156 10 E 0.874,1.806 1.041,1.962 0.167,0.156 10 F

Apply battery voltage across the terminals.


iii.

Check that air flows from ports.

If the result is not as specified, replace the purge VSV.