Home › Engine / Hybrid System › 3UR-FE LUBRICATION › OIL PUMP
RM27M0U _51 Engine / Hybrid System _049114 3UR-FE LUBRICATION _0234071 OIL PUMP G

3UR-FE LUBRICATION  OIL PUMP  INSPECTION  


PROCEDURE

Hide 1.INSPECT OIL PUMP RELIEF VALVE

a.
A162535

Coat the relief valve with engine oil.


b.

Check that the relief valve falls smoothly into the valve hole by its own weight.

If the relief valve is not as specified, replace it. If necessary, replace the timing chain cover sub-assembly.


Hide 2.INSPECT OIL PUMP ROTOR SET

a.
A162536E07
1.49,0.354 0.969,0.354 0.969,0.354 1.521,1.052 true 0.219,0.281 0.969,0.677 0.75,0.396 10 true Matchmark

Install the rotors to the timing chain cover with the rotors' marks facing outward. Check that the rotors revolve smoothly.


b.
A162537

Check the tip clearance.

i.

Using a feeler gauge, measure the clearance between the drive and driven rotor tips, as shown in the illustration.

Standard tip clearance:

0.180 to 0.300 mm (0.00709 to 0.0118 in.)


Maximum tip clearance:

0.300 mm (0.0118 in.)


If the tip clearance is greater than the maximum, replace the timing chain cover sub-assembly.



c.
A162538

Check the side clearance.

i.

Using a feeler gauge and steel square, measure the clearance between the rotors and steel square as shown in the illustration.

Standard side clearance:

0.030 to 0.090 mm (0.00118 to 0.00354 in.)


Maximum side clearance:

0.090 mm (0.00354 in.)


If the side clearance is greater than the maximum, replace the timing chain cover sub-assembly.



d.
A162539

Check the body clearance.

i.

Using a feeler gauge, measure the clearance between the timing chain cover and driven rotor as shown in the illustration.

Standard body clearance:

0.175 to 0.250 mm (0.00689 to 0.00984 in.)


Maximum body clearance:

0.250 mm (0.00984 in.)


If the body clearance is greater than the maximum, replace the timing chain cover sub-assembly.