Home › Drivetrain › TIRE AND WHEEL › TIRE PRESSURE WARNING VALVE AND TRANSMITTER
RM27M0U _52 Drivetrain _049120 TIRE AND WHEEL _0234090 TIRE PRESSURE WARNING VALVE AND TRANSMITTER A

TIRE AND WHEEL  TIRE PRESSURE WARNING VALVE AND TRANSMITTER  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.REMOVE REAR WHEEL

Hide 42607 3.REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER

a.

Remove the cap and valve core to release the air from the tire.

NOTICE:

Keep the removed cap.



b.

After ensuring that a sufficient amount of air has been released, remove the nut and washer used to secure the tire pressure warning valve and transmitter. Then drop the tire pressure warning valve and transmitter with the grommet into the tire.

HINT:

The grommet may remain attached to the rim.



c.
C180021E08
0.771,1.458 0.896,1.458 0.896,1.458 1.177,1.188 true 2.344,1.052 2.656,0.802 2.656,0.802 2.802,0.802 true 0.49,1.365 0.792,1.552 0.302,0.188 10 false Tire 2.854,0.719 3.219,0.938 0.365,0.219 10 false Shoe 2.219,1.729 2.427,1.938 0.208,0.208 10 false (A)

After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of a tire remover.

NOTICE:
·

Be careful as the tire pressure warning valve and transmitter may become damaged due to interference between the sensor and tire bead.

·

Set the tire remover shoe as shown in the illustration.

Width (A):

10 to 20 mm (0.394 to 0.787 in.)





d.

Separate the upper bead.


e.

Take out the tire pressure warning valve and transmitter with the grommet from the tire and separate the lower bead.


f.

Remove the grommet from the tire pressure warning valve and transmitter.