47201
1.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
Install a new brake master cylinder seal onto the brake master cylinder.
Install the brake master cylinder with 2 new nuts.
47311
2.CONNECT FRONT NO. 1 BRAKE TUBE
Using a union nut wrench, connect the brake tube (labeled A) to the brake master cylinder.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
47321
3.CONNECT REAR NO. 1 BRAKE TUBE
Using a union nut wrench, connect the brake tube (labeled B) to the brake master cylinder.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
4.CONNECT BRAKE FLUID LEVEL WARNING SWITCH CONNECTOR
Connect the brake fluid level warning switch connector.
5.BLEED BRAKE SYSTEM