Home › Brake › BRAKE › BRAKE MASTER CYLINDER
RM27M0U _54 Brake _049123 BRAKE _0234116 BRAKE MASTER CYLINDER A

BRAKE  BRAKE MASTER CYLINDER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Release the vacuum from the booster by depressing the brake pedal several times. Then remove the brake master cylinder sub-assembly from the brake booster assembly.


PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

Immediately wash off any brake fluid that comes into contact with any painted surfaces.


Hide 2.DISCONNECT BRAKE FLUID LEVEL WARNING SWITCH CONNECTOR

C154470

a.

Disconnect the brake fluid level warning switch connector.


Hide 47311 3.DISCONNECT FRONT NO. 1 BRAKE TUBE

a.
C208549E02
1.917,0.917 2.052,1.073 0.135,0.156 10 true A 1.833,1.813 1.979,2 0.146,0.188 10 true B

Using a union nut wrench, disconnect the brake tube (labeled A) from the brake master cylinder.


Hide 47321 4.DISCONNECT REAR NO. 1 BRAKE TUBE

a.

Using a union nut wrench, disconnect the brake tube (labeled B) from the brake master cylinder.


Hide 47201 5.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.
C154471

Remove the 2 nuts and brake master cylinder from the brake booster.

NOTICE:
·

The master cylinder requires careful handling. Do not allow the master cylinder to receive any impact, such as from being dropped. Do not reuse a master cylinder that has been dropped.

·

Do not strike or pinch the master cylinder piston, and do not cause any damage to the master cylinder piston by any other means.

·

When installing the master cylinder to the brake booster, or when removing the master cylinder from the brake booster, make sure that the master cylinder is kept horizontal or with its tip facing downward (the piston faces upward) to prevent the master cylinder piston from falling out.

·

Do not allow any foreign objects to contaminate the master cylinder piston. If a foreign object gets on the piston, remove it by using a piece of cloth, and then apply an even layer of lithium soap base glycol grease around the circumference (sliding part) of the piston.

·

Do not use any other type of grease or fluid.

·

Be careful not to damage the brake tubes.




b.

Remove the brake master cylinder seal from the brake master cylinder.