Home › Brake › BRAKE › BRAKE BOOSTER
RM27M0U _54 Brake _049123 BRAKE _0234117 BRAKE BOOSTER G

BRAKE  BRAKE BOOSTER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 44610 1.INSPECT BRAKE BOOSTER

C123869

a.

OPERATING CHECK

i.

Depress the brake pedal several times with the engine off and check that there is no change in the pedal reserve distance.


ii.

Depress the brake pedal and start the engine. If the pedal goes down slightly, operation is normal.



b.
C123870E05
0.5,1.677 0.74,1.833 0.24,0.156 10 false 1st 0.865,1.583 1.135,1.74 0.271,0.156 10 false 2nd 1.177,1.344 1.427,1.5 0.25,0.156 10 false 3rd 0.208,0.104 0.948,0.271 0.74,0.167 10 false CORRECT 1.979,0.104 2.875,0.281 0.896,0.177 10 false INCORRECT

AIRTIGHTNESS CHECK

i.

Start the engine and stop it after 1 or 2 minutes. Depress the brake pedal several times slowly.

If the pedal goes down farthest the 1st time, but gradually rises after the 2nd or 3rd time, the booster is airtight.


ii.

Depress the brake pedal while the engine is running, and stop the engine with the pedal depressed. If there is no change in the pedal reserve travel after holding the pedal for 30 seconds, the booster is airtight.



Hide 44730 2.CHECK BRAKE VACUUM CHECK VALVE ASSEMBLY

a.

Check the check valve.

i.

Slide the clip and disconnect the vacuum hose.


ii.

Remove the check valve from the booster.


iii.
C155487E02
0.635,0.104 1.333,0.271 0.698,0.167 10 false Ventilation 2,0.115 2.917,0.281 0.917,0.167 10 false No Ventilation

Check that there is ventilation from the booster to the engine, and no ventilation from the engine to the booster.

If the results are not as specified, replace the check valve assembly.