Home › Brake › BRAKE › FRONT BRAKE FLEXIBLE HOSE
RM27M0U _54 Brake _049123 BRAKE _0234118 FRONT BRAKE FLEXIBLE HOSE A

BRAKE  FRONT BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 47313A 1.INSTALL FRONT FLEXIBLE HOSE

a.
C353276E01
0.542,3.729 0.688,3.885 0.146,0.156 10 true A 1.719,1.99 1.854,2.177 0.135,0.188 10 true A

Attach 2 new clips (labeled A) to the flexible hose.


b.

Using a union nut wrench, connect the flexible hose to the brake tube and wheel cylinder tube while holding the flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake tube and wheel cylinder tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube and wheel cylinder tube from the connecting points.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




Hide 42603 3.INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)