Home › Brake › BRAKE › REAR BRAKE FLEXIBLE HOSE
RM27M0U _54 Brake _049123 BRAKE _0234120 REAR BRAKE FLEXIBLE HOSE A

BRAKE  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 47321B 1.INSTALL REAR BRAKE FLEXIBLE HOSE

a.
C155439

Install the flexible hose and a new gasket to the disc brake cylinder with the new union bolt.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)

HINT:

Install the flexible hose lock securely in the lock hole in the cylinder.



b.

Set the flexible hose to the connecting point with the brake tube, and then attach a new clip.


c.
C353269

Using a union nut wrench, connect the flexible hose to the brake tube while holding the flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




Hide 42603 3.INSTALL REAR WHEEL

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)