Home › Brake › BRAKE › FRONT BRAKE
RM27M0U _54 Brake _049123 BRAKE _0234121 FRONT BRAKE A

BRAKE  FRONT BRAKE  INSTALLATION  


PROCEDURE

Hide 43512 1.INSTALL FRONT DISC

a.
C155464E02
1.75,1.188 2.521,0.948 2.521,0.948 1.771,1.115 false 2.563,0.854 3.292,1.156 0.729,0.302 10 true Matchmark

Align the matchmarks, and then install the front disc.

HINT:

When replacing the front disc with a new one, select the installation position where the front disc has the smallest runout.



Hide 2.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH

a.
C154478

Install the disc brake caliper with 2 new bolts.

Torque:
180 N*m (1835 kgf*cm, 133 ft.*lbf)


Hide 47317 3.CONNECT NO. 7 FRONT BRAKE TUBE

a.
C208567

Using a union nut wrench, connect the front brake tube.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 04465 4.INSTALL FRONT DISC BRAKE PAD KIT

a.
C155459E03
0.5,0.406 1.052,0.406 false 1.823,2.083 1.479,2.49 1.479,2.49 1.479,1.813 false 1.01,0.74 1.573,0.74 false 0.625,2.99 1.844,3.198 1.219,0.208 10 false Disc brake grease 0.938,2.521 1.927,2.698 0.99,0.177 10 false Disc Brake Pad 1.094,0.313 2.542,0.51 1.448,0.198 10 false No. 2 Anti-squeal Shim 1.615,0.656 3.042,0.875 1.427,0.219 10 false No. 1 Anti-squeal Shim

Apply a light coat of disc brake grease to both sides of the No. 1 anti-squeal shims.


b.

Install the No. 1 and No. 2 anti-squeal shims to each pad.


c.
C155460

Install the 2 pads to the disc brake caliper.


d.
C155461

Install the front disc brake anti-rattle spring between the 2 pads.

NOTICE:

The anti-rattle spring can be used again if it has sufficient rebound; no deformation, cracks or wear; and has had all rust, dirt and foreign matter cleaned off.



e.
C154476

Install the 2 hole pins.


f.

Install the pin hold clip.

NOTICE:

The pin hold clip can be used again if it has sufficient rebound; no deformation or wear; and has had all rust, dirt and foreign matter cleaned off.



Hide 42603 6.INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)