Home › Brake › PARKING BRAKE › PARKING BRAKE SWITCH
RM27M0U _54 Brake _049124 PARKING BRAKE _0234126 PARKING BRAKE SWITCH G

PARKING BRAKE  PARKING BRAKE SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84550 1.REMOVE PARKING BRAKE SWITCH ASSEMBLY

Hide 84550 2.CHECK PARKING BRAKE SWITCH ASSEMBLY

a.
C159029E08
2.229,1.063 2.875,1.219 0.646,0.156 10 false Pushed in 2.219,0.615 2.844,0.771 0.625,0.156 10 false Released 0.115,0.094 2.542,0.469 2.427,0.375 10 false Component without harness connected: (Parking Brake Switch)

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Switch Condition Specified Condition
1 - Switch body ground Parking brake switch ON (Switch pin released) Below 1 Ω
Parking brake switch OFF (Switch pin pushed in) 10 kΩ or higher


If the result is not as specified, replace the parking brake switch assembly.


Hide 84550 3.INSTALL PARKING BRAKE SWITCH ASSEMBLY