Home › Drivetrain › AB60E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM
RM27M0U _52 Drivetrain _049126 AB60E AUTOMATIC TRANSMISSION / TRANSAXLE _0234159 AUTOMATIC TRANSMISSION SYSTEM D

AB60E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  MANUAL SHIFTING TEST  


MANUAL SHIFTING TEST


HINT:
·

Through this test, it can be determined whether the trouble occurs in an electrical circuit or if it is a mechanical problem in the transmission.

·

If any abnormalities are found in the following test, the problem is in the transmission itself.



a.
C291296E01
0.666,0.09 2.290,0.270 1.624,0.181 10 No. 2 Transmission Wire 1.398,0.495 3.022,0.675 1.624,0.181 10 No. 1 Transmission Wire 1.548,1.521 1.282,0.59 1.282,0.59 1.365,0.59 false 1.192,1.74 0.516,0.199 0.516,0.199 0.599,0.199 false

Disconnect the connector of the No. 1 transmission wire and/or No. 2 transmission wire.

HINT:

It is possible to deactivate the electrical shift control by disconnecting the transmission wires. The gear positions can then be changed mechanically with the shift lever.



b.

Drive the vehicle with the transmission wires disconnected. Move the shift lever to each position to check whether the gear position changes as shown in the table below.

Shift Lever Position Gear Position
P P
R R
D
·

4th*1

·

1st to 6th*2



HINT:
·

*1: When disconnecting only the No. 1 transmission wire or the No. 1 and No. 2 transmission wires.

·

*2: When disconnecting only the No. 2 transmission wire.




c.

Connect the connector of the No. 1 transmission wire and/or No. 2 transmission wire.