Home › Drivetrain › A760E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE
RM27M0U _52 Drivetrain _049128 A760E AUTOMATIC TRANSMISSION / TRANSAXLE _0234179 TRANSMISSION WIRE A

A760E AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  REMOVAL  


PROCEDURE

Hide 1.DRAIN AUTOMATIC TRANSMISSION FLUID

a.

Remove the drain plug and gasket, and drain the ATF.


b.

Install a new gasket and the drain plug.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


Hide 35106 2.REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

C209348

a.

Remove the 20 bolts, oil pan and gasket from the transmission.

NOTICE:

Some fluid will remain in the oil pan. Remove all the pan bolts, and carefully remove the oil pan assembly.



b.
AT00103

Examine the particles in the pan.

i.

Remove the 4 magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.

Steel (magnetic): bearing, gear and clutch plate wear

Brass (non-magnetic): bush wear



Hide 35330 3.REMOVE VALVE BODY OIL STRAINER ASSEMBLY

C209698

a.

Remove the 4 bolts and oil strainer.

NOTICE:

Be careful as some fluid may leak out of the oil strainer.



b.

Remove the O-ring from the oil strainer.


Hide 82125J 4.DISCONNECT TRANSMISSION WIRE

C209349E02
1.936,1.431 2.273,1.62 0.337,0.189 1.936,1.431 1.936,1.62 false 2.273,1.62 2.273,1.431 false 2.272,1.431 1.942,1.431 false 2.272,1.619 1.942,1.619 false 2.476,1.068 2.813,1.257 0.337,0.189 2.476,1.068 2.476,1.257 false 2.813,1.257 2.813,1.068 false 2.813,1.068 2.482,1.068 false 2.813,1.256 2.482,1.256 false

a.

Remove the 2 bolts and 2 temperature sensor clamps.


b.

Disconnect the 2 ATF temperature sensors.


c.

Disconnect the 9 solenoid valve connectors.


d.

Detach the wire harness from the 2 clamps.


Hide 82125J 5.REMOVE TRANSMISSION WIRE

U148191

a.

Disconnect the wire connector.

i.

Detach the claw, press down the lever, and then disconnect the transmission wire connector.



b.
C125286

Remove the bolt and pull out the transmission wire.


c.

Remove the O-ring from the transmission wire connector.