Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY(for Manual Tilt)
RM27M0U _55 Steering _049129 STEERING COLUMN _0234193 STEERING COLUMN ASSEMBLY(for Manual Tilt) A

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for Manual Tilt)  REASSEMBLY  


PROCEDURE

Hide 45877A 1.INSTALL STEERING COLUMN BRACKET SPACER

a.
C352988E01
1.885,2.156 2.094,2.354 0.208,0.198 10 false *a 1.896,2.406 2.104,2.604 0.208,0.198 10 false *a

Fix the steering column in a vise between aluminum plates or a cloth. Then install the steering column bracket spacer to the steering column.

Text in Illustration
*a 15°

NOTICE:
·

Install the steering column bracket spacer so that it is facing in the direction shown in the illustration.

·

When using a vise, do not overtighten it.




Hide 84450 2.INSTALL IGNITION SWITCH ASSEMBLY

a.
C155157

Attach the 2 claws to install the ignition switch to the steering switch bracket.


Hide 85432 3.INSTALL KEY INTERLOCK SOLENOID

a.
C155158

Install the key interlock solenoid to the steering lock with the 2 screws.


Hide 84052 4.INSTALL UNLOCK WARNING SWITCH ASSEMBLY

a.
C155156

Attach the 2 claws to install the unlock warning switch to the steering switch bracket.


Hide 69057A 5.INSTALL IGNITION SWITCH LOCK CYLINDER

a.

Check that the ignition switch lock cylinder is in the ACC position.


b.
C352989E01
2.906,0.167 3.219,0.365 0.313,0.198 10 false *d 2.448,0.354 2.76,0.552 0.313,0.198 10 false *c 2.302,0.74 2.615,0.938 0.313,0.198 10 false *b 2.531,1.281 2.844,1.479 0.313,0.198 10 false *a

Install the ignition switch lock cylinder to the steering lock.

Text in Illustration
*a LOCK
*b ACC
*c ON
*d START


c.

Check that the ignition switch lock cylinder is securely installed.


Hide 6.INSPECT STEERING LOCK OPERATION

Hide 45271 7.INSTALL UPPER STEERING COLUMN CLAMP WITH SWITCH BRACKET ASSEMBLY

a.

Temporarily install the upper steering column with switch bracket and the steering lock bracket with 2 new tapered-head bolts.


b.
C155159

Tighten the 2 tapered-head bolts until the bolt heads break off.


Hide 89783 8.INSTALL TRANSPONDER KEY AMPLIFIER (w/ Engine Immobiliser System)

a.

Align the transponder key amplifier with the installation position of the upper bracket with the amplifier inclined.


b.
C155160

Push the transponder key amplifier upward and install it to the upper switch bracket.

NOTICE:

Do not push the amplifier up with excessive force.



Hide 81870D 9.INSTALL KEY CYLINDER LIGHT ASSEMBLY (w/o Engine Immobiliser System)

a.

Align the key cylinder light with the installation position of the switch bracket with the key cylinder light inclined.


b.
C155160

Push the key cylinder light upward and install it to the switch bracket.

NOTICE:

Do not push the key cylinder light up with excessive force.