When installing parts, coat the parts indicated by arrows with power steering fluid (See page Steering>POWER STEERING>VANE PUMP(for 1UR-FE)>COMPONENTS).
1.INSTALL VANE PUMP HOUSING OIL SEAL
Coat the lip of a new oil seal with power steering fluid.
Using SST and a press, press in the oil seal.
Make sure that the oil seal is installed facing in the correct direction as shown in the illustration.
44303A
2.INSTALL VANE PUMP SHAFT SUB-ASSEMBLY WITH PULLEY
Coat the inside surface of the bushing in the vane pump front housing with power steering fluid.
Gradually insert the vane pump shaft sub-assembly with pulley.
| *a | Protective Tape |
Do not damage the lip of the oil seal in the front housing.
Wrap protective tape around the spline of the vane pump shaft with vane pump shaft sub-assembly with pulley in order to prevent damage to the oil seal.
3.INSTALL VANE PUMP FRONT SIDE PLATE
Coat a new O-ring with power steering fluid and install it into the front housing.
Coat a new O-ring with power steering fluid and install it onto the front side plate.
Align the notch of the front side plate with the notch of the front housing, and install the front side plate.
| *a | Match |
Make sure that the front side plate is installed facing in the correct direction.
4.INSTALL VANE PUMP CAM RING
Coat the cam ring with the power steering fluid.
Align the notch of the cam ring with the notch of the front side plate, and install the cam ring with the inscribed mark facing upward.
| *a | Inscribed Mark |
| *b | Match |
Make sure that the cam ring is installed facing in the correct direction.
5.INSTALL VANE PUMP ROTOR
Install the vane pump rotor.
The vane pump rotor can be installed in both directions.
Coat the 10 vane pump plates with power steering fluid.
Install the vane pump plates with the round end facing outward.
| *a | Round End |
| *b | Outward |
Make sure that the vane pump plates are installed facing in the correct direction.
6.INSTALL VANE PUMP SHAFT SNAP RING
Using a screwdriver and snap ring expander, install a new shaft snap ring onto the vane pump shaft.
7.INSTALL VANE PUMP REAR HOUSING
Coat a new O-ring and straight pin with power steering fluid and install it onto the rear housing.
Align the straight pin of the rear housing with the notches of the cam ring, front side plate, and front housing.
| *a | Match |
Install the rear housing with the 4 bolts.
8.INSPECT TOTAL PRELOAD
44330
9.INSTALL FLOW CONTROL VALVE ASSEMBLY
Coat the flow control valve with power steering fluid.
Install the compression spring and flow control valve to the front housing.
Coat a new O-ring with power steering fluid and install it onto the pressure port union.
Install the pressure port union to the front housing.
44337
10.INSTALL POWER STEERING SUCTION PORT UNION
Coat a new O-ring with power steering fluid and install it to the suction port union.
Install the suction port union to the vane pump with the bolt.