Home › Steering › POWER STEERING › STEERING GEAR
RM27M0U _55 Steering _049130 POWER STEERING _0234203 STEERING GEAR G

POWER STEERING  STEERING GEAR  INSPECTION  


PROCEDURE

Hide 45047 1.INSPECT TIE ROD END SUB-ASSEMBLY LH

a.
C132329

Secure the tie rod end LH in a vise.


b.

Install the nut to the stud bolt.


c.

Flip the ball joint back and forth 5 times or more.


d.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.

Standard turning torque:

1.0 to 3.9 N*m (10 to 40 kgf*cm, 9 to 34 in.*lbf)


If turning torque is not within the specified range, replace the tie rod end LH.


Hide 45046 2.INSPECT TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedures described for the LH side.