Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM27M0U _58 Vehicle Interior _049131 SUPPLEMENTAL RESTRAINT SYSTEMS _0234204 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  CHECK MODE PROCEDURE  


CHECK MODE PROCEDURE (Using Techstream)


NOTICE:

Select "Signal Check" from the "DTC Check" screen displayed on the Techstream to clear the output DTCs (both present and past).


HINT:
·

DTCs can be detected more sensitively in check mode than in normal diagnosis mode.


·

Perform check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.



a.

Check and ensure the following conditions:

i.

Battery positive voltage 11 V or higher.


ii.

Shift lever in the P or N position.


iii.

A/C switch off.



b.

Turn the ignition switch off.


c.

Connect the Techstream to the DLC3.


d.

Turn the ignition switch ON.


e.

Turn the Techstream on.


f.

Enter the following menus: Body Electrical / SRS Airbag / Check Mode.