Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
81496
1.INSTALL REAR COMBINATION LIGHT GUIDE
If the rear combination light assembly LH is removed, replace the rear combination light guide.
Use the same procedure for both rear combination light guides.
Attach the 2 claws to install a new rear combination light guide.
81560
2.INSTALL REAR COMBINATION LIGHT ASSEMBLY LH
Put protective tape around the rear combination light assembly LH.
Connect each connector.
Attach the 2 clips to install the rear combination light assembly LH.
Using a T30 "TORX" socket wrench, install the 2 screws.
| *1 | Protective Tape | - | - |