Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81560
1.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
Put protective tape around the rear combination light assembly LH.
Using a T30 "TORX" socket wrench, remove the 2 screws.
Detach the 2 clips.
Disconnect each connector and remove the rear combination light assembly LH.
| *1 | Protective Tape | - | - |
81496
2.REMOVE REAR COMBINATION LIGHT GUIDE
If the rear combination light assembly LH is removed, replace the rear combination light guide.
Use the same procedure for both rear combination light guides.
Using a screwdriver, detach the 2 claws and remove the rear combination light guide.
Tape the screwdriver tip before use.
| *1 | Tape |