Home › Vehicle Interior › LIGHTING › LIGHTING SYSTEM
RM27M0U _58 Vehicle Interior _049133 LIGHTING _0234252 LIGHTING SYSTEM J

LIGHTING  LIGHTING SYSTEM  Front Fog Light Circuit  


DESCRIPTION

The main body ECU receives a front fog light switch information signal from the light control switch (front fog switch), and illuminates the front fog lights.

WIRING DIAGRAM

E146023E09
2.74,3.984 3.586,4.152 0.846,0.167 10 A31 1.92,2.81 3.488,2.978 1.568,0.167 10 Front Fog Light Bulb LH 1.92,2.633 2.766,2.800 0.846,0.167 10 A30 2.74,4.162 4.676,4.329 1.936,0.167 10 Front Fog Light Bulb RH 3.964,1.865 4.336,2.026 0.372,0.161 10 FOG 4.499,1.125 4.641,1.285 0.142,0.161 10 2 4.507,1.62 4.649,1.780 0.142,0.161 10 5 3.658,1.601 3.800,1.762 0.142,0.161 10 3 3.638,1.134 3.780,1.295 0.142,0.161 10 1 0.56,1.491 1.378,1.671 0.818,0.179 10 from Battery 0.233,1.027 1.302,1.206 1.069,0.179 10 from TAIL Relay 5.658,1.143 5.786,1.299 0.128,0.156 10 4 5.842,1.041 6.249,1.191 0.407,0.150 10 FFGO 5.768,2.96 6.794,3.102 1.026,0.142 10 Main Body ECU 5.768,2.825 6.794,2.967 1.026,0.142 10 J4 3.491,3.813 3.630,3.986 0.139,0.173 10 2 3.139,3.815 3.287,4.017 0.147,0.203 10 1 2.64,2.449 2.779,2.623 0.139,0.173 10 2 2.289,2.451 2.436,2.654 0.147,0.203 10 1 2.008,1.638 2.358,1.807 0.350,0.170 10 FOG

CAUTION / NOTICE / HINT

HINT:

Inspect the bulbs for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (FRONT FOG LIGHT)
a.

Operate the Techstream according to the steps on the display and select "Active Test".

Main Body
Tester Display Test Part Control Range Diagnostic Note
Front Fog Light Relay Front fog light ON or OFF -

OK:

Front fog light turns on / turns off.




OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT FUSE (FOG)
2.INSPECT FUSE (FOG)
a.

Remove the FOG fuse from the engine room junction block.


b.

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
FOG fuse Always Below 1 Ω




OK

3.CHECK HARNESS AND CONNECTOR (FRONT FOG LIGHT BULB - BATTERY)

NG

REPLACE FUSE

3.CHECK HARNESS AND CONNECTOR (FRONT FOG LIGHT BULB - BATTERY)
U152886E02
0.146,0 2.51,0.677 2.365,0.677 10 false Front view of wire harness connector: (to Front Fog Light Bulb LH) 0.479,1.427 0.802,1.594 0.323,0.167 10 false A30

a.

for LH:

i.

Disconnect the A30 front fog light connector.


ii.

Measure the voltage according to the value(s) in the table below.

Standard voltage:
Tester Connection Switch Condition Specified Condition
A30-2 - Body ground Light control switch TAIL, front fog light switch ON 11 to 14 V
Light control switch TAIL, front fog light switch OFF Below 1 V




U152887E02
0.146,0 2.531,0.646 2.385,0.646 10 false Front view of wire harness connector: (to Front Fog Light Bulb RH) 0.5,1.417 0.823,1.583 0.323,0.167 10 false A31

b.

for RH:

i.

Disconnect the A31 front fog light connector.


ii.

Measure the voltage according to the value(s) in the table below.

Standard voltage:
Tester Connection Switch Condition Specified Condition
A31-2 - Body ground Light control switch TAIL, front fog light switch ON 11 to 14 V
Light control switch TAIL, front fog light switch OFF Below 1 V





OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (FRONT FOG LIGHT BULB - BODY GROUND)

NG

4.INSPECT FOG LIGHT RELAY (FOG)
4.INSPECT FOG LIGHT RELAY (FOG)
E121182E11
1.724,1.093 1.835,1.242 0.111,0.149 10 5 1.779,0.046 1.889,0.194 0.111,0.149 10 1 3.197,0.107 3.308,0.256 0.111,0.149 10 2 1.69,1.712 1.800,1.860 0.111,0.149 10 3 1.312,1.428 1.422,1.577 0.111,0.149 10 3 1.299,0.878 1.409,1.027 0.111,0.149 10 2 0.353,0.874 0.464,1.023 0.111,0.149 10 1 0.362,1.424 0.473,1.573 0.111,0.149 10 5 1.862,1.183 2.269,1.084 false 2.269,1.583 1.806,1.785 false 2.14,0.624 1.857,0.225 false 2.764,0.533 3.168,0.242 false

a.

Remove the fog light relay from the engine room relay block.


b.

Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
3 - 5 When battery voltage is not applied to terminals 1 and 2 10 kΩ or higher
When battery voltage is applied to terminals 1 and 2 Below 1 Ω




OK

5.CHECK HARNESS AND CONNECTOR (FOG LIGHT RELAY - BATTERY)

NG

REPLACE FOG LIGHT RELAY

5.CHECK HARNESS AND CONNECTOR (FOG LIGHT RELAY - BATTERY)
U152777E02
0.042,0.031 2.802,0.677 2.76,0.646 10 false Component without relay: (Engine Room Relay Block, Junction Block) 1.302,1.104 2.802,1.427 1.5,0.323 10 false Fog Light Relay (FOG)

a.

Remove the fog light relay from the engine room relay block.


b.

Measure the voltage according to the value(s) in the table below.

Standard voltage:
Tester Connection Switch Condition Specified Condition
Fog light relay terminal 1 - Body ground Light control switch TAIL 11 to 14 V
Fog light relay terminal 3 - Body ground Always




OK

6.CHECK HARNESS AND CONNECTOR (FR FOG RELAY - FRONT FOG LIGHT BULB)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK HARNESS AND CONNECTOR (FR FOG RELAY - FRONT FOG LIGHT BULB)
U152889E01
0.411,0.01 3.146,0.356 2.735,0.346 10 Component without relay: (Engine Room Relay Block, Junction Block) 0.843,0.652 2.346,0.830 1.503,0.178 10 Fog Light Relay (FOG) 4.266,0.176 6.635,0.601 2.369,0.424 10 Front view of wire harness connector: (to Front Fog Light Bulb) 4.282,1.498 4.567,1.663 0.284,0.165 10 A30 4.294,1.882 4.586,2.047 0.291,0.165 10 A31 4.693,1.498 4.891,1.663 0.198,0.165 10 *1 4.693,1.872 4.891,2.037 0.198,0.165 10 *2 0.154,2.016 0.782,2.191 0.628,0.174 10 *1: for LH 0.154,2.348 0.782,2.522 0.628,0.174 10 *2: for RH 1.485,2.07 0.56,0.711 0.56,0.711 0.778,0.711 false

*1: for LH

*2: for RH


a.

Remove the fog light relay from the engine room relay block.


b.

Disconnect the A30*1 and A31*2 front fog light connectors.


c.

Measure the resistance according to the value(s) in the table below.


Standard resistance:
Tester Connection Condition Specified Condition
Fog light relay terminal 5 - A30-2*1 Always Below 1 Ω
Fog light relay terminal 5 - Body ground*1 Always 10 kΩ or higher
Fog light relay terminal 5 - A31-2*2 Always Below 1 Ω
Fog light relay terminal 5 - Body ground*2 Always 10 kΩ or higher



OK

7.CHECK FRONT FOG LIGHT

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.CHECK FRONT FOG LIGHT
U152776E01
0.06,0.049 2.445,0.399 2.385,0.350 10 Front view of wire harness connector: (to Main Body ECU) 1.63,1.36 1.855,1.516 0.225,0.156 10 J4 0.309,3.082 0.739,3.231 0.430,0.149 10 FFGO 0.483,3.048 1.847,2.223 false

a.

Disconnect the J4 ECU connector.


b.

Using a service wire, connect J4-4 (FFGO) on the wire harness side and body ground.


c.

Check that the front fog light illuminates.

OK:

Front fog light illuminates.




OK

REPLACE MAIN BODY ECU

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (FOG LIGHT RELAY - MAIN BODY ECU)