Home › Vehicle Interior › LIGHTING › CARGO LIGHT SWITCH
RM27M0U _58 Vehicle Interior _049133 LIGHTING _0234257 CARGO LIGHT SWITCH G

LIGHTING  CARGO LIGHT SWITCH  INSPECTION  


PROCEDURE

Hide 84260 1.INSPECT DECK LIGHT SWITCH ASSEMBLY

E145554E02
1.386,2.941 1.848,3.092 0.461,0.151 10 CGON 0.556,2.924 0.976,3.075 0.420,0.151 10 CGLP 2.527,2.924 2.946,3.075 0.420,0.151 10 CCTY 2.108,2.924 2.279,3.075 0.171,0.151 10 E 2.303,2.402 2.704,2.913 false 1.404,2.399 1.627,2.916 false 1.203,2.385 0.802,2.918 false 1.839,2.407 2.148,2.908 false 0.069,0.024 0.419,0.326 0.350,0.302 10 *a

a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (CCTY) - 9 (CGON) Cargo light switch ON Below 1 Ω
Cargo light switch DOOR
Cargo light switch OFF 10 kΩ or higher
10 (CGLP) - 7 (E) Cargo light switch ON Below 1 Ω
Cargo light switch DOOR 10 kΩ or higher
Cargo light switch OFF


If the result is not as specified, replace the deck light switch assembly.

Text in Illustration
*a Component without harness connected
(Deck Light Switch Assembly)



b.
E145554E03
2.63,1.289 2.985,1.440 0.355,0.151 10 ILL+ 0.653,1.209 0.953,1.360 0.299,0.151 10 ILL- 2.28,1.971 2.733,1.478 false 1.174,1.999 0.848,1.421 false 0.08,0.052 0.426,0.356 0.346,0.304 10 *a

Check the illumination.

i.

Apply battery voltage to the connector and check the illumination condition.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1 (ILL+)
Battery negative (-) → Terminal 4 (ILL-)
Illuminates


If the result is not as specified, replace the deck light switch assembly.

Text in Illustration
*a Component without harness connected
(Deck Light Switch Assembly)